NEED HELP FAST? We have over 48+ years' experience with Bulk Material Handling, Packaging, and Processing. (979) 217-1480 GET A QUOTE
NEED HELP FAST? (979) 217-1480 GET A QUOTE
Category | Bulk Processing Equipment |
Vibrating screens process wood chips
These vibrating screens process wet, green wood chips before sending them to a dryer. A total of (3) vibrating screens were used to remove the fines from the wood chips. The fines are diverted to a combustor and used for fuel.
Each screen uses a natural frequency drive system, with an industrial vibration motor to power the system. The screen decks are interchangeable and replaceable as needed.
Category | Bulk Processing Equipment | Dewatering Equipment & Screens |
Fluid bed dryer for pre-crushed pumice
This vibrating fluid bed dryer is used to remove the surface and internal moisture from pre-crushed pumice. The ore enters the system via a belt conveyor and feeds the dryer. Air heated by natural gas is processed through the fluid bed dryer, removing the moisture. Moisture laden gas is sent to a dust collector to remove any entrained fines before the gas is released into the atmosphere. The dried ore is then discharged from the dryer onto a conveyor and sent to a storage silo.
Category | Bulk Processing Equipment |
Hot rebar cuts and drops on conveyor
Short cuts, or drops, from a steel mill producing reinforcing bars, square, and round stock, are dropped from the hot bar shear onto two vibratory conveyors. The conveyors move the short cuts of rebar away from the shearing table and into portable roll away containers. The collected cuts are then recycled back to the electric arc furnace for remelting.
Category | Bulk Processing Equipment | Pneumatic Conveying Systems |
Pneumatic Conveying System for Ash Under Hoppers
This pneumatic conveying system is designed specifically for conveying hot abrasive ash, such as bottom ash (or fly ash) from boiler beds, baghouses, or electrostatic precipitators. These systems can handle temperatures up to 650°F (1,800°F with assembly) and can be arranged in a single line of 1 to 10 units. The Macawber pneumatic conveying systems also use about 50% less energy than typical fly ash conveying systems.
Watch a Video
Category | Bulk Processing Equipment |
carbon black feed stock solids separator
The Derrick Solids Separator is designed to remove solids from feedstock oil. The system operates continuously and is designed for unattended operation, low maintenance, and produces clean oil and dry stackable solids. Solids loading in the feedstock oil does not effect the efficiency of the system.
Remove solids from feedstock oil located in: